Manitou Systems Inc.

RF Power Attenuators

These modules are used when the RF power signal needs to be reduced in a 50 ohm circuit. The excess power is dissipated as heat energy. Typically used when a higher power RF generator (i.e., 300 watts) is used in an application that requires 30 watts. A 10dB attenuator is used to reduce the effective output power by a factor of 10 enabling a high control resolution in between 0 and 30 watts. Another application may be to slightly attenuate one or more outputs of a passive power divider to correct for hardware or process variations.

Accessory	Notes	Order #
RF Power Attenuators	.	.Consult factory
Attenuator Module	.	Consult factory

Request Literature

Manitou Systems Inc.
18 Commerce Road, Newtown, CT. 06470
Tel.203.270.8797 Fax.203.270.8786

This website has been revised as of 03.25.07

Any technical specification described on this website is subject to change without prior notice.

Thank you for visiting the Manitou Systems, Inc. website. Our privacy policy is simple: we collect no personal information about you unless you choose to provide that information to us. We do not give, share, sell or transfer any personal information to a third party.